Renault Laguna I - Phase 2 - Bodywork - Front Bumper Repair - Renault Forums :: Independent Renault forum

LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old 13th October 2005 Thread Starter
Join Date: Aug 2005
Posts: 52
Nominated 0 Times in 0 Posts
TOTW/F/M Award(s): 0
Thanks: 0
Thanked 0 Times in 0 Posts
Thumbs up Renault Laguna I - Phase 2 - Bodywork - Front Bumper Repair

This may help someone with a similar problem.

The bumper on the front right side had a bulge where the previous owner had pranged something and dislodged the front corner of the bumper. No amount of external persuasion could get it back in so I found the following solution.

I removed the front right wheel. To the front of the wheel arch there is a section of the wheel arch protection that is held in place by three hex nuts at the top and two underneath. Remove these and remove the panel.

On the outer part of the wheel arch where the external panels begin there is one screw (can't remember what those Renault star shaped screws are called?) Remove this.

If you now look up and right into the area to the front of the wheel arch you will see another hex screw. This screw is a key type screw. It will not come off. It purpose is to lock the panelling to the body of the car.

Open the bonnet. Above the wheel arch in the panelling you will see the top of this screw and also the two groves cut into the panelling to which the screw must be rotated to release the panel.

Holding the socket in one hand and watching the position from above you can release this section of the bumper. The bumper will not come away fully but just enough to see the next fixing point. In my case the source of my problem.

The next fixing point is a grove cut into the plastic bumper this grove slides onto a pin. Both a easily visible. The grove and pin had separated. Levering the plastic back over the pin the plastic returned to its original position.

To replace everything I followed the above instructions in reverse.

Note: When the wheel arch protection is removed there is a piece of electric trunking attached to the back of it. I believe that this is for the fog lights. There is a connecter just inside the engine compartment behind the wheel. Mine came apart directly when I removed the panel however you may need to reach in and release this. When replacing this it can be a little difficult as you cannot see what you are doing and have to rely upon touch to make the connection.

Hope this is helpful to somebody.


Dark Jupiter is offline  
  5 Lastest Threads by Dark Jupiter
Thread Forum Last Poster Replies Views Last Post
Laguna I Phase II Heated seats Interiors bonedavid 1 1562 21st October 2006 01:07 PM
Wiring Additional Headlights Electronics Horatio 1 1628 21st October 2005 07:35 PM
Central locking affected by cold weather? Electronics Shaun wall 28 7911 17th October 2005 08:18 PM
Renault Laguna I - Phase 2 - Interiors - How to... Laguna geochr 6 9697 14th October 2005 09:30 PM
Can your floor mats look like new? Interiors Garvey69 3 1953 13th October 2005 10:45 PM
Sponsored Links
post #2 of 2 (permalink) Old 31st January 2006
Platinum member
Oilyrag's Avatar
Join Date: Jan 2006
Posts: 2,875
Nominated 0 Times in 1 Post
Nominated TOTW/F/M Award(s): 1
Thanks: 19
Thanked 28 Times in 27 Posts
On a stuborn plastic bumper sometimes a little heat from a hairdrier will cause just enough give in the plastic to get it looking right. I did this a few weeks ago for a neighbour and it has worked a treat.

I am not an alcoholic. Alcoholics go to meetings:D "
Currently in Oilyrag's garage:
59 Vauxhall Zaffira 1.6 Life & 1957 Austin A35
Oilyrag is offline  

bodywork , bumper , laguna , phase , renault , repair

Quick Reply

Register Now

In order to be able to post messages on the Renault Forums :: Independent Renault forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may not post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome