Independent Renault Forums banner

Megane II Cambelt & Dephaser just changed. Engine Management light now on?!

3K views 2 replies 2 participants last post by  andyellis111 
#1 ·
Can anyone advise what it may be?

Car runs & starts spot on!

Thanks
 
#2 ·
-------------------------------
I've just serviced my Megane.
To reset it, start up the engine. Then repeatedly press/release the button on the end of the right hand stalk, until you bring up the 'service display.'
Next press the small nob
(sticks out about 1/4 '') it is located on the right hand side of the left hand dial.
Press it for about 30 seconds or until the service
data rests. Next 'service mileage' is then featured.
Hopefully this will reset the panel lights.
Some engineers advise, the management system
indicators will reset itsself, after running for a period of time also.
Personally I've previously had it reset via a computer (Dear, if your garage does not already use one).
Or used my own plug in 'fault' computer to reset it.
Renaults do appear to have some distinctive tastes of software.A cut above or BELOW-the other makes.
Congratulations that your motor is running sweet after the major refit. Some are reporting trouble, after the latest dephasers have been fitted -not necessarily through the part - possibly a software tweak needed!

Trust you have noted that it is recommended, that the new belt tension is checked after 500 miles.

I've booked mine in for a cambelt refit, plus the advised water pump plus serpintine belt.
As for the De-phaser pully -WoW!
One hopes that is OK when we do the refit.
I'm not a mechanic, but cannot get a new mortgage - The planned service quotes just kept going up & up.
£100 per hour >>>
book time 3.9 hours cambelt refit!!
SamWoe
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top