Join Date: Nov 2011
Nominated 0 Times in 0 Posts
TOTW/F/M Award(s): 0
Thanked 4 Times in 3 Posts
Re: Laguna II 2006 Fog Lamp access
Hi. I don't mind telling you how to remove the bumper as part of the question.
Firstly lift the bonnet and the front grille is removed by pressing a plastic tag to release the grille in the centre as you look down,
I used to use an open ended 17mm spanner which seemed to do the job well,
the grille should then be removed.
From underneath you will need to remove some 10mm bolts that hold the bumper trim to the subframe,
and release the side plastic quadrants by removing 1/2 20 torx screws,
a couple of black plastic mushroom clips.
Behind the inner wheel arch liners in line with the top of the bumper there is one 10mm bolt to be removed each side and then you should be able to slide the bumper forwards to release it.
I believe your vehicle will have headlamp washers,
so you may need to disconnect the washer piping at the quick release union behind the bumper,
but if you are just resting the bumper on the floor,
you can leave all connected and remove the 10mm nuts for the fog lamp in question,
release the wiring connector and swap over the unit.
I would also advise checking they work before refitting.
As long as you don't have any seized bolts etc the front bumper should take no more than 30 minutes to remove and refitting is even easier as you know how it all fits together.
Access to all of the fixings is quite easy,
just a little tricky for your first time until you realise where they are.
Not a great deal holds the front bumper on in all honesty. I hope this helps. Kind regards
Currently in terlark's garage:
2002 renault laguna II 1.8 privalage