Renault Forums :: Independent Renault forum - View Single Post - Suspension clunk on a Laguna II

View Single Post
post #8 of (permalink) Old 10th June 2007 Thread Starter
Join Date: May 2007
Posts: 80
Nominated 0 Times in 0 Posts
Nominated TOTW/F/M Award(s): 1
Thanks: 0
Thanked 7 Times in 4 Posts
This is how to do it, (sorry, no photos)
1. Chock the rear wheels,
2. Jack up the car and support on two axle stands and remove the front wheels. (Take note of which wheel goes which side. Put the wrong one on and the car will not drive!!!!!)
3. Remove the two plastic trim screws either side of the struts in the engine bay. (Be patient and they'll come off easily). Pull back the weather strip and lift back the plastic cover.

4. The strut has one nut (I think 20mm -Can be done with a large spark plug socket) and two 13mm bolts. Undo and store safely)

5. In the wheel arch, there are two 20mm bolts holding the strut to the hub. Soak these with WD40, taking care not to spray the discs. Then, using your plug socket, unscrew the nuts. These will be tight.
6. Top tip!!!! Put a jack underneath the lower ball joint to support the hub. If you let the hub slip, you car accidently drop out the driveshafts!!!!
7.The bolts will still be in place because they have locating splines on them. Put the socket on and turn them just until they 'give'. you can then tap them out with a solf hammer or mallet.

8. The final bolt to remove is the anti roll bar droplink. This is a 16 mm nut and requires a spanner and allen key. Hold the threaded rod with the allen key and slowly work the nut back and forth to remove. Take your time as these can be stubborn and require liberal dosings of wd40.

9. The strut is now free and can be removed from the car. take care not to hit the wheel arch is you go.

10. Lock the strut in a vice by its mounting point using an appropriate piece of wood between the blades and not on the shaft. Using spring compressors, retract the spring. You should now be able to push back the bearing/ mount assembly to reveal a 17mm nut. Using an allen key to hold the shaft in place, unscrew using a spanner. You will now be able to lift off the bearing and rubber mount. Refitting is the reversal of removal.

Remember to fit new locking nuts all the way round.

Warning - We are not stupid on here but removing springs can be lethal. Don't use any home made tools buy a decent set of spring compressors.

Refer to Haynes or other manual for torque settings
Currently in goon's garage:
Citroen C4 VTS - The Laguna has moved on to pastures new!

Last edited by goon; 10th June 2007 at 06:24 PM.
goon is offline  
For the best viewing experience please update your browser to Google Chrome