Join Date: Feb 2012
Nominated 0 Times in 0 Posts
TOTW/F/M Award(s): 0
Thanked 11 Times in 7 Posts
I'll add this here too as you asked on the other thread, so it's all on one thread.
To install the guide pipes.
You need to lift up the carpet in the rear of the car.
Remove rear seats, easy enough, clip off black plastic cover from rear seat bracket and unbolt the bracket.
Remove front passenger seat, 4 hex bolts.
I left driver seat in. It is probably easier if you take it out though.
Remove centre pillar cover where the seat belt goes in by lifting up from the bottom and pulling out from the top, needs a bit of force but just clips off, clip off rear door carpet threshold.
Start peeling the carpet up from the rear, you will find one bolt in each floor storage cupboard, remove.
Roll the carpet forward and your ready to install the guide pipes once you remove the blanking caps.
Sounds a bit complicated but everything goes back nice and neatly.
Also note that there is a welded metal piece in the centre of the rear floor, the guide pipes go either side of this, not through the holes in it.
Currently in Jon67's garage:
Renault scenic 2004 1.6