Renault Forums :: Independent Renault forum - View Single Post - Clio MK2 Leaking Sunroof

View Single Post
post #2 of (permalink) Old 28th March 2012
HeatherJ's Avatar
Join Date: Dec 2010
Posts: 10,327
Nominated 7 Times in 9 Posts
Nominated TOTW/F/M Award(s): 3
Thanks: 2,040
Thanked 1,687 Times in 1,255 Posts
Re: Clio MK2 Leaking Sunroof

Found this post it may help you!
Originally Posted by sap123 View Post
Suggested Solution
Repairs to Renault Clio 98/05 Sunroof
Repair of a sunroof on a Renault clio can be carried out by anyone who likes a bit off a challenge
Tools Needed are ;
***8226; one 10 mm
***8226; ratchet spanner
***8226; one sealer gun
***8226; tube of silicone sealer clear or black is best one
***8226; bottle of white sprit
***8226; old rags to clean up
***8226; glass cleaner
***8226; latex gloves
***8226; bog spreader/plastic card

Lets start, as sunroof fitters we are aware there is a big problem with the Sunroofs in clios so were going to help you fix it. Starting in the driver seat, open the handle on a manual roof, behind the handle you will see the joint in the trim which holds the headlining to the roof. Take hold of the trim by the joint, pull forward and remove the trim. Once the trim is removed the headlining can be pulled down slightly to reveal the 10mm bolts. The housing unit which contains the light is not fixed by screws and can just be pulled down in one complete unit. By holding the head lining down approximately 4 - 5 inches the 10mm ratchet spanner can be used to remove the bolts which hold the lower frame to the upper frame. Once all bolts are removed the sunroof drain pipes which are located in the 2 front corners need to be pushed forward to separate them from the sunroof frame. Once this is achieved the sunroof can now be lifted out starting from the back. Once the sunroof has been removed from the vehicle glass side down you will find that the roof was fitted with a damning tape from the factory, once you have found this you have now found the problem. Remove the damning tape with a flat headed screw driver. Clean the back with white spirits, wait for the spirit to evaporate. Whilst the spirit is evaporating the roof needs to be cleaned any damning tape which is stuck to the roof should be removed. Once dry then we can apply the silicone sealer to the upper frame of the sunroof. Don***8217;t be shy when applying sealant i recommend going round twice. Using a pair of latex gloves pick up the sunroof and replace into position make sure that the sunroof is sat correctly remove gloves enter the car and begin to replace the 10mm bolts. Once all bolts are fully tightened the pipes which are located at the front can be reconnected. The headlining trim can now be put back and the interior light calving can now be pushed back into position. From the outside of the vehicle all excess sealer can be removed with a bog spreader or a plastic card. Do not use a metal scraper as this can scratch the roof. Once excess sealer has been removed using a rag and white spirit clean off the remainder the sealer once this has been achieved spray glass cleaner on glass and paint work and polish up. Job well done.hope this helps as found it on the .
From here ATTENTION clio mk 2 sunroof fix :)
Currently in HeatherJ's garage:
Peugeot 407 SW and a Honda Hornet 900cc
HeatherJ is offline  
The Following User Says Thank You to HeatherJ For This Useful Post:
bazzey (28th March 2012)
For the best viewing experience please update your browser to Google Chrome