Hello everybody peeps,
Newbie here...very confused
and hoping you can help please.
Need to replace front discs & pads for the MOT and want to do them myself with an engineer friend.
But there seems to be a bit of confusion about
1) Bleeding the system
2) Releasing the handbrake cable adjustment etc.
Obviously I would open the master cylinder, unscrewing the cap but do i also need to open the bleed screw to retract the calliper piston?
Where is the bleed screw located?
Do i also need to release the handbrake cable adjustment and disconnect the cable ends from the calliper?
Finally, i keep seeing 'Copper Grease' mentioned - What & Where is this used? (Only clean,printable answers please
All answers gratefully received...ta