Hi.Have followed the procedure to remove flashing spanner without success.It appears to re-set itself back to 0 and so the spanner starts to flash again.I've also tried to re-set by holding stalk before inserting card but still no joy.Any suggestions/
Try this ( from the Laguna 11 e-handbook off this website - look for previous models)
extract from the e-handbook:
Resetting the display after service in accordance with the maintenance schedule
The mileage before
change/service must only be reset after a service complying
with the recommendations in the Maintenance Service Booklet. If you decide to
more frequently, do not reset this data each time the
This prevents the replacement interval from being exceeded for other parts
included in the maintenance schedule.
With the ignition switched on, select the “mileage before
on the display. Keep key 2 pressed for more than 10 seconds. The value on the
display flashes 4 times and is then replaced by the reset mileage before
value. This flashes 4 times. Release key 2, the value is lit up and stored.