Independent Renault Forums banner

Repace Stereo in Scenic 2009

2K views 2 replies 2 participants last post by  earlgreaves 
#1 ·
Hello all.

I'm looking to replace the stereo on my 2009 Scenic 1.6 VVT Dynamique and would appreciate some advice on the connectors I'll need to buy. The new unit will probably be an Alpine.

1. Definitely will need an interface to use the steering stalk controls, but after searching several sites I'm still not exactly sure which is the right one for my needs. Is the CTRN005, 006 or 007, or DS-RN005 or 007 ?

http://www.dynamicsounds.co.uk/conn...enic-twingo-stalk-control-adaptor-p-9094.html

http://www.dynamicsounds.co.uk/conn...cenic-wind-stalk-control-adaptor-p-15349.html

http://www.dynamicsounds.co.uk/conn...ic-traffic-stalk-control-adaptor-p-15350.html

http://www.dynamicsounds.co.uk/rena...ring-wheel-control-stalk-adaptor-p-10500.html

http://www.dynamicsounds.co.uk/rena...eel-control-stalk-interface-lead-p-25210.html

2. Probably also a fascia - not sure exactly which ...

3. Will I also need an airiel connector ?

And is this a fiddly job that I'll be able to do with basic common sense, or should I look at getting the new unit fitted ?

Thanks !
 
See less See more
#2 ·
If you don't know what you are getting as yet its a little hard to help.

I was thinking about doing the same thing on my Laguna and putting in my Kenwood.
Even though I would get my ten changer back, rather than the Renaults six and a better head unit and maybe be able to use the control stalk, if I got the add on.
But the down side is, I will loose all the dash display for the cd/radio.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top