Independent Renault Forums banner

bleeding

  1. Transmissions
    Evening all, I've a query if you're not too busy at some point this evening. So, after breaking down the other week, we had the slave cylinder replaced. Since then, the pedal had been a little soft in the mornings and would stiffen up after driving for a few miles. I suspected some air in...
  2. Transmissions
    I hope someone can shed some light on this problem, having read all about bleeding these clutches I find it still had a problem so I changed the master cylinder. I clamped the pipe from the feed on the brake master cylinder and changed the cylinder no problem but after trying to bleed it without...
  3. Transmissions
    Hey, So 2weeks ago the mechanic changed the flywheel and clutch because the trust had somewhat broken down. After those where replaced i went to try it out and the pedal was giving me only half way. When i told him about it, he told me that the master Cylinder needs to be changed. Having said...
  4. Brakes/Hubs
    Can anyone tell me the procedure to bleed the brakes on a 2004 Espace using Renault can Clip? I have located the functions to to this in Clip, but I need to know how to use it. Need a full system bleeding after changing the ABS module, think there is still air in the pump because the pedal feels...
  5. Transmissions
    This morning I had to go and bleed the lads clutch system On his megane there are 3 clips, Two of these clips are before the bleed nipple, First clip nearest the gearbox, this is to stop the pipe coming all the way off. The other one, this allows the system to be bled.. So the one nearest to...
  6. Transmissions
    Hi All . I'm new on here. I own a Renault Espace and the clutch started going soft and I would have to pump it to get the car in gear in the morning. So I decided to bleed it. I made a bit of a booboo and plugged it out from where it says clip one. Now there is no pressure at all on the clutch...
  7. Transmissions
    Hi All, please help I have my Espace IV 2004 2.2Dci 6sp Manual G9t, PK6 A week ago the clutch floored, leaving me in half panic.. luckily outside my garage.. not hitting anyting living. I hoped for air in the system.. so bleed I thought. I have looked at all the posts I fund on on the forum...
  8. Older renaults (pre-1992)
    hi all i am looking into replacing brake fluid and then bleeding the brakes, i have looked at them and the rear brakes seem to have 2 nipples each side :censored: can anybody let me know if i need to bleed both nipples or just the one per side, if so which one, as one is lower down than the...
  9. Heating & cooling
    hi everyone can anyone tell me were the bleeding screw to release the air lock from the coolant system is car 2012 Renault scenic 1.5 dci i know on the 2007 model its on the hose above the gear box but this one god all mighty is a pain to locate
  10. General Chat
    Who are these people who drive White Crashcries:grin2: Plonkers they are:grin2::grin2: Nipped Currys earlier and nothing was parked near me and when I came out this was "neatly" parked next to me:wink2:
  11. Brakes/Hubs
    Hi there i just fitted a abs pump to my master,have bled brakes,get a average pedal until i start up and pedal goes straight to floor.i think abs pump has air still in it,but how do i get it out, would pressure rising brake servo and pushing back do the trick,i have fluid at each nipple but...
  12. Engines
    Hey guys, I'm pretty sure I know what I need to do but I have a problem with my car were I keep getting check injection warnings after having one of the metal injection lines blow (twice), the line was replaced and now this issue keeps cropping up and it's getting worse. Now I'm pretty sure...
  13. Transmissions
    hi all I am new to the forum , I have just fitted a new clutch to my 1.9 dci 2005 scenic. but I am having trouble getting a good clutch pedal I have looked at some threads about this but I am still having no joy, I have tried gravity bleed ,easy bleed, leaving the bleed nipple open over night(...
  14. Transmissions
    Replaced the dfm and the clutch pressure and release bearing however when removing the external slave cylinder--- air was somehow introduced causing a spongy clutch pedal.( no problem before repair) As a sealed system with no nipple on the slave has anyone tried to bleed this sealed system the...
  15. Engines
    I bled my clutch today, but when I depress the clutch pedal, the union shoots off, even with the clip on. I have pushed it onto the spigot as far as I can get it, even bending the clip so that it will grip tighter, but it is not doing it. Also how many o-rings must there be on the spigot that...
  16. Brakes/Hubs
    Hi, There are countless threads across the interweb regarding this issue but I am hoping the right person reads this and can give a definitive answer. My brakes were previosuly alot spongeier than any other vehicle ive owned and the pedal would sink to the floor over time. I recently...
  17. Electronics
    A couple of days ago a couple of spots appeared on my display. Over the last few days these have spread into a zigzag pattern. What has caused this and how can I prevent further spreading?
  18. Heating & cooling
    Hello, can you tell me how you bleed the cooling system after a water pump change on a 2000 renault laguna 1.9dci f9q engine. thanks.
  19. Transmissions
    Help please, I've just replaced the clutch on my 2004 1.9 dci Scenic with a single mass kit but cannot get the clutch to bleed properly. I initially bled it using a syringe and drew the fluid through the slave bleed nipple. I tried to start the engine a few hours later. But the pedal went to the...
  20. Transmissions
    I hope this may help someone... :cool: I've just been through a couple of hours long struggle of bleeding our Scenic RX4 hydraulic clutch. :( Normal bleeding (2 man: press clutch, close nipple, release clutch, open nipple, etc.) did not work well at all, except to get rid of some really dirty...
Top