driveshaft

Hi, I recently bought a Laguna 3 GT from 2008 with PK4008 gearbox and 2.0T 205hp engine mapped to 230hp by the previous owner. It currently has 114k mileage, I made around 3k miles so far. I noticed this wind-like whine right when I bought it when it was at 18" wheels in the summer, it was...

My Grand Scenic has a dodgy drivehsaft (I think). The spring is slightly twisted and the shaft pulls out (cv boot not secure) but not from the transmission. I think I need to change it but how do I get the part out of the transmission. Just pull? Iv'e tried to look for this on the forum but...

Hi! I had to replace the driveshaft seal/gaiter on my Renault Laguna 2001 Type 2. Originally I had to change the outer one (left side/drivers side), so I emptied the gear oil and took out the drive shaft and fitted the new one. I put things together again and filled up the oil in the gear...

I have a 1994 Chausson campervan based on a Renault flatbed, this is a LHD Dutch registered vehicle. I suppose the flatbed could have been a little bit older than 1994. When searching for parts on internet supplier sites the registration number always brings up Renault Trafic Open Chassis PXX...

HELP!!!! I need to replace the driveshafts on my Renault Laguna Coupe 2011 2.0DCI I have the new driveshafts but i cannot locate a supplier for the right or left hand differential output seal. These need to be replaced as well. Also having difficulty with what to call them. I sourced a workshop...

Hi Guys. Im a Renault noob so bear with me ;) One of my friends has a Clio IV, it have some bad knocking noices, I found around 3-4mm play in the bearing for the innder CV joint on the left side of the car. Do any of you know if its posible to change that bearing from the outside? or is it a...

Hi All, the engine is rebuilt with head skim and back in. I had problems fitting the driver's side driveshaft being the one with the centre bearing holder bolted to the sump/block. the gearbox had been drained and refreshed with new oil. on start up with the shafts turning in the air I'm leaking...

Hi, I need to replace the n/s driveshaft on my 1.5dci 51 plate clio. I have found a spare/repair same age but a 1.2l. Will it fit? Thanks for your help Molly Sent from my VTR-L09 using Tapatalk

Hi there, hoping someone can help a beginner DIY'er with a problem.. New user, Recently bought my wife an old 2001Y clio 1.2 (8v I believe). It was cheap and off the road at the time so could not test drive it. Apart from the common sunroof leak and some of the other 'quirks' of the car that...

Can anyone tell me how best to remove the outer RHS driveshaft of an Espace IV diesel left hand drive. This is the side with the shaft extension from the gearbox to an intermediate support bearing. I can see that the inner rubber gaiter has completely disintegrated and would like to replace the...

Hi everyone: it’s a bit hard finding the answer to this in New Zealand where my coupé is unique—though it may have the most common configuration of any petrol model in the UK. I own a 10 reg Mégane III I-Music coupé, with the 1·6 110 PS petrol engine. I showed my mechanic this link, but his...

Since replacing both driveshafts my ABS, STOP light and handbrake light on. Speedo only reads 20mph and brakes fail at low speed. Do I have to reset ECU codes?

hi all just a quickie...i had the driveshaft oilseal(passenger side)replaced on my clio mk3..i still have oil coming out so im going down the route of replacing the passenger side driveshaft as i and other people seem to think thats the problem. now ive looked all over for a driveshaft,to no...

folks heres a tip if your having issues removing a driveshaft from the gearbox (C-Clip designed ones) on my TL4 gearbox the driveshaft has a little c clip that compresses as you push or pull into the splines and then snaps out into a groove in the diff housing. the issue is this clip is made of...

Hi I'm in the process of changing my front shock absorbers. I had loosened the big nut on the driveshaft and thought that the driveshaft would stay in place as I was knocking with a hammer on the metal piece where the shock absorber is connected ( dont know the english word for it) Anyway I got...

I damaged my N/S/F inner CV boot while doing my ball joints. The Shaftec kit with bearing BK126C fitted a treat.If you have access to a press it is quit an easy job to do,and should take about 2 hours. You will need about 3.25 Lt of gear oil. I used 80-90 because it was all I had and the gear...

Does anyone know how to remove the NS driveshaft on a 1.6 16v scenic (2011)? I cant get the inner cv joint out of the gearbox, I cant see any roll pins clips etc. From looking at the replacement shaft I have there is just a clip on the end of splines similar to an outer cv joint.

Any advice on how to source driveshafts - renault do not make them any more and I'm told that my model does not have drive shafts that are able to be reconditioned. Thanks in advance!

Hey guys new to the forum I've owned my Renault Laguna iii for about 6 month now and it needs a new driveshaft it's the 2.0 dci 150bhp initiale 2007-2012 version engine code m9r . I can't find a second hand passenger side driveshaft anywhere and don't really want to put a brand new one on so I...

Hi guys, i have a megane 1 2002 1,9dci with F9Q732 and JC5 gearbox. I lost drive a week ago. When i removed the right drive shaft i found that gearbox adapter/sleeve splines were eaten out on the side of differential. I was happy that i dont need to remove the gearbox and i replaced the...