does anyone know the torque limit/specification for the stock clutch on the Clio mk3 1.5dci 106hp?
I'm thinking of getting it tuned and just want to make sure it's not gonna completely fry the clutch
Just about to replace the rear discs on a 2009 2.0 Turbo Laguna III Coupe (petrol)
Have already read about and had one panic attack, with reference to electronic parking brake restrictions when compressing calipers.
But have just had the wheel off, and the motor is on the rear cross member...
I have this issue with my 2014 Megane 3, 1.5 dCi, 110 HP. Mileage 130.000
When accelerating, the torque is delivered in pulses, not big fluctuations but enough to be noticed.
During engine braking, occasional vibrations occur in a few seconds, and at low speeds at low engine speeds, there...
Hi all, my first post hope someone can help with this.
I’m planning on doing the cambelt this weekend (if the rain holds off lol) I’ve got a couple of questions I hope someone could answer. My car is a 2006 1.5 dci the 106bhp version.
First question, I’ve just had a quick look (it was quick it...
Can anyone tell me the toque specs for the following:
1) Caliper Slider Bolts
2) Caliper Bracket Bolts
3) Central Hub Nut
I also have a few general questions:
1) Should the bleeder valve be open before pushing the caliper piston back?
2) Are the Brake Rotors held on by the Hub Nut...
My car occasionally goes into limp mode(every time I enter my work car park, I assume the bump on the way in disturbing the wiring, a quick restart fixes it). So I attached the ODB reader and took a screenshot when driving because I could smell fuel, this was driving at taround...
Good day all,
I have been assembling a Scenic 2 f9q 812 engine. I thought I would spend a few euros more on the new head bolts so I bought Elring bolts because I have always thought their products were of superior quality. I searched around for head bolt torque information and decided to follow...
Hope you can help...brand new to the forum!
I have a 64 plate megane coupe and I want to change the rear disks and pads.... only I cant find the torque specs anywhere!
Specifically, for the main hub bolt, caliper bolts, stud bolts etc...
Any help would be very much appreciated...
Does anyone know which tightening torque it should be on connecting rod bearing and big end bearings? Should also need one on the oil pump bolts if there is. For my engine Renault Espace 2.0T -04 F4R-794
I have a Renualt megane 5 door mk2 2006 1.6 16v petrol.
I need to take off my inlet manifold as there is mess all in between the channels.
Does anyone know the:
1) Tightening sequence of the bolts.
2) What the torque specs are (Nm) for the bolts.
Sent from my SM-G900F using Tapatalk