[ours2012]

Will your interface perform a forced regen?

 

[ours2012]

Have you looked under Cabin filter section
What interface is it ?

 

[ours2012]

Autocom should do a regen ( DElphi should so this easily )
Dont hold me to this as not used it for a few months

Do an ISS, now untick everything other than the diesel engine
Allow it to scan, now go to read codes ,
Then below that on that page that opened should be something like tic tic ( Or words to that ) , use the drop down section, should see regen
Follow on screen instructions
AND dont get out the car, or switch radio on or touch brakes
It gets a bit scary , if at any time you are worried YOU CAN stop it at any time by switching ignition off ..
It will rev up on its own
BEFORE you do a static regen, make sure car is parked on concrete, not on tarmac, you have at Least a 1/4 of a tank of Fuel in, and enough oil in the engine

 

[ours2012]

Did you find the place, or my instructions no good
Will put Delphi on the Scenic tomorrow and check if you need me to and then take note of how to get there

 

[ours2012]

Its just have engine running, un tick all other boxes other than diesel

If you have fault codes
Its delete fault codes, switch ignition off wait at least a minute
Now start the engine Do an iss only on engine DONT read fault codes and go for the regen setting see if it will work then

You could try going in on OBD , IGNORE engine off ( It wont damage your Delphi on Renault,)