Independent Renault Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello everyone i'm new to the forum, just got a few questions.
After the cam belt snapped on my brothers clio y reg 1.2 8 valve, i rebuilt the head with new valves (7 bent but replaced 8).I set the tappets a bit wide as put new valves (lapped in) and stem seals in. The car sounds ticky on idle but is has a quite steady idle, the only thing is now the car jerks when driving in low gears below 3k rpm, could this be one of the tappets not allowing full closure of a valve. Anybody know the tappet settings for this engine, and do they need to be set hold or cold. Cheers Bobby
 
A

·
Guest
Joined
·
0 Posts
Sorry I can not help with your question but a warm welcome
to the forum
 
1 - 5 of 5 Posts
Top