Independent Renault Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1 (Edited)
Well the on going nightmare still continues.
After previous posts on here explaining the initial cutting out and restarting of the van, it has now completely cut out with all dash lights on and the red picture of an engine with stop on it is flashing.
It was plugged into a snap on diognostics and came up with many dealer only codes and they are not possible to clear.
What is wrong with it now?
If its the ecu, I have an ecu, loom and transponder bits to change it. But will it need re coding?
Someone please help me.
 

·
Registered
Joined
·
24 Posts
Discussion Starter #3
I didn't take a note of the faults. There was about 30 of them though.
Now when you plug it in it says failure to communicate with ecu.
 
1 - 3 of 3 Posts
Top