[ClioClioII]

Have you replaced the impact sensor?

Clio, crash sensor location | Independent Renault Forums

]Hello! Thank you for your reply. I found that old thread shortly after my post I am still a bit confused to where it is located. The a-pillar or the b-pillar?

 

[ClioClioII]

Hello again! So today I looked for the impact sensor. I don't know if this is the right one. It's located at the bottom of the b-pillar, underneath the trim. I am attaching pictures. Maybe this is the side one and not the front one? The Ohm reading for it is 14. I don't know if that is normal or not? I could see there was corrosion inside the connector going to the sensor. Sadly it's hard to remove this as I can't get the pins out. I used some electrical cleaning spray but the light will not come off. Maybe I could solder the wire directly to the sensor though. Please help with all of your suggestions 😊👍🏻 Thanks in advance!

 

[ClioClioII]

can you compare ohm resistance with other measure on airbag i think that is too much resistance

Hello. Thank you for your reply 😊👌🏻 So where should I measure?

 

[ClioClioII]

This would suggest that you are right... 😊👍🏻

 

[ClioClioII]

Hello again! Luckily I just got Autocom. Even though I am a beginner I managed to confirm that the driver seat sensor is faulty. The Ohm reading is apparently 414 and not 14! So clearly there is a problem with the sensor. A used one is on its way. Hopefully it will solve the problem 😊👍🏻

 

[ClioClioII]

Yes! A used crash sensor made the SRS-light go away 😊👍🏻 Thank you all for your help and especially @ClioAutomatic and @nikovitkovic2 🙏🏻