Depends on access.... which was a pain on the Mark 2, not looked at the Mk3.
Renault's E guide seems to make it easy but no idea what may be in the way, like battery, washer bottle filler ???

E-GUIDE.RENAULT.COM / New-Scenic / Take care of your vehicle (Lens units) / HEADLIGHTS: changing bulbs

Direction indicator lights Turn bulb holder 1 a quarter of a turn and take out the bulb. Bulb type: PY21W. Once the bulb has been replaced, check that it is properly secured.

gb.e-guide.renault.com

 

Meg III video...dunno if this is possible with the Scenic III but if the lamps come out that easy, does save a lot of problems.

 

Unfortunately it's a completely different setup on the Scenic

 

Had to take the bumper of on our GSII. It was a lot easier than I imagined.
I had tried to do it from the back but ended up unhooking the tilt motor and took ages.

 

How do you change the headlight bulb on a Renault Scenic 3?

Cannot find any guides or videos

Thanks

take off rubber cap remove elec plug, release metal clip in one direction I cannot remember if its left or right push to one side, remove bulb note tab to top, replace and test before puuting back together.

 

I will update for completeness

Managed to get my hand in behind the headlight and change the bulb without having to remove bumper or headlights as is easier to do with previous models

Remove plastic cap from rear of bulb
Remove connector
Turn bulb 45 degrees
Remove bulb

The one I changed was very difficult to turn but in the end it gave and it has now been changed

Refitting is reversal of removal

 

This is the drivers side dipped bulb on my 2010 Grand Scenic. Bulb won't budge, can't see any clips holding it in. Should this bulb be twisted 45 degrees or should it pull straight out? Any help appreciated. Very tight for access. Thanks

 

Spring clip is not in photo, have you removed it? If not has someone glued it in place. It would normally just pull out

 

Wiggle it gently from side to side as you pull it firmly straight out, it’s held in by spring clips at each side which will give.
Note the position of the tab on the bulb and put the new one in exactly the same way, you’ll feel it click as it locks into position.

 

Hi

my 2006 Megane was the same, leaving the connector on is a good tip for wiggling and pulling out the old bulb.
Its also a good idea to fit it onto the new bulb for the same reason, also helps you not to touch the new bulb in the process. however do not pull on the wires they are not attached well enough and not designed for that purpose.
Make sure you align the tab in the correct position and push the bulb all the way in.
The number of cars I've seen where owners are complaining of poor lights is where the bulbs have not been either fitted with the tab in the right lace or bulbs not pushed home.

Al

 

Problem is the handbook actually instructs you to turn the bulb 1/4 of a turn and remove but you can’t and don’t as the tab won’t let you.
My bulb holders are the same as in the picture and work just like the mk2 megane.

 

Hi

I wondered about that with my Megane hand book, I think its a typo, as its the indicator bulb that needs the 1/4 turn.
The projector h/amps are push & pull with just the side spring clips holding it in.

Al

 

Thanks for the help guys. Yes, the manual does say to turn them... They pulled out after a bit of wiggling around first. Rammed the new ones in good and straight. Worked a treat.

 

Thanks. Just done mine; I had to use a bent nail to pull the bulb out, 10 minute job + a bit of blood.....